pedzel2.png

szukasz Profesjonalnych rozwiązań?

Wypełnij krótki formularz, a nasz doradca skontaktuje się  w możliwie krótkim czasie

 

 Formularz kontaktowy

Start > Start > Products > Akrylen

Packaging 

0,7 l, 5 l

Efficiency 

8-10 m²/l

Approvals 

PZH

norm

PN-C-81907:2003

Akrylen

Half-matt acrylic enamel – for wood and metals

 

Use:

A Non-yellowing, waterborne acrylic enamel for protective and decorative painting of interior & exterior wooden surfaces, wood-based, metal, plaster (eg paneling. Finished half-matt coatings exhibit very good adhesion to the substrate, high durability, flexibility and good resistance to mechanical damage. Additional advantages of enamel are: a mild odor during application and drying time much shorter compared to conventional solvent-based enamels. Due to the low emission of volatile components it can be used in rooms for permanent residence. Suitable coating composition gives good resistance to changing weather conditions and water.

 

Surface preparation and application:

The surfaces to be coated should be clean, dry and free of grease, stains and dust. Raw, dry wood substrate should be impregnated and  primed, when dry, sanded and dedusted. Areas with resin must be cleaned with petroleum ether and dried. Old coats of alkyd enamel or oil sheen should be roughened with sandpaper and thoroughly vacuumed. Unpainted metal substrate should be primed with an anti-corrosive. Inadequate surface preparation may cause peeling and other coating defects.Mix the enamel thoroughly before use. Paint the prepared, dry surface with the undiluted enamel ( in commercial form ).If it thickens it can be slightly diluted with tap water right before application. Avoid excessive water, excessive dilution decreases the quality of the coat.Perform painting at a substrate and ambient temperatures above +10 ° C and relative humidity below 80 %,  using a flat brush with soft bristles, sponge flock roller or spray. Next layer can be applied after about 4 hours. (lower temperature and higher humidity extend the drying time ). Complete drying is acheieved in 24 hours at ambient conditions. Wash painting  tools with water immediateliy after finishing work.

 

Safety precautions:

Keep out of the reach of children. Avoid direct contact with the product. In case of contact wash with soap and water,change  soiled clothing. Rinse eyes immediately with plenty of running water for at least 20 minutes. If irritation develops, consult a doctor.

  • coating appearance: smooth, silky,
  • paint with roller, brush or spray after appropriate dilution,
  • paint at +10-25 ° C
  • storage at +5-30 ° C
  • drying time, depending on the substrate and ambient conditions: about 4 hours
  • paintingof  the next layer: no earlier than after 4 h.,
  • recommended number of layers: 1-3,
  • Efficiency: 8-10 m2 / l,
  • cleaning tools and dilution  tap water,
  • PZH Hygienic Certificate,
  • Norm PN-C-81907: 2003,
  • Cat. A/d/FW. Maximum allowable VOC content for this category: 130 g / L. The paint has <110 g / l
  • Warranty: 18 months from date of manufacture
  • Packaging: 0.7 liters, 5 liters. 

 

With the release of the new version of the previous card expires.

Ta strona używa ciasteczek (cookies), dzięki którym nasz serwis może działać lepiej.